Ignore stationary IR-Source

From Smoothboard

If your Presenter stationary IR-Source is in the field of view of your primary Wiimote, it will interfere with the Whiteboard. This process ignors an IR-Light detected at the location of your stationary IR-Source.

Smoothboard will ignore an IR-Light within a radius of the location. It is recommended not to place a stationary IR-Source near the calibrated monitor or outside toggle areas.

Contents 1 Locate the 'Ignore IR-Source settings' 2 Calibrate Wiimote 3 Temporarily disable cursor 4 Place your stationary IR-Source 5 Ignore Current IR-Source position

Locate the 'Ignore IR-Source settings'

1. Click 'Show Settings' on the main window
2. Select 'Whiteboard' on the top navigation
3. Select the 'Presenter Mode' tab

Calibrate Wiimote

1. Click 'Calibrate Wiimote'
2. Calibrate the primary Wiimote as normal

Temporarily disable cursor

You need to disable cursor control to prevent your stationary IR-Source interfering with the Whiteboard while you are putting it in place. It will be reinstated automatically after the last step

1. Click 'Temporarily disable cursor'

Place your stationary IR-Source

1. Place your stationary IR-Source in your preffered location
2. Look at the Calibration visual in the main window
   1. Check the IR Dot: count is only '1' and you can see a small red circle that is located correctly in relation to the white square.

Ignore Current IR-Source position

1. Click 'Ignore Current IR-Source position'
2. Click 'OK' for the window that gives the loaction of the stationary IR-Source

The process is complete and you cursor control has automatically been restored.